The staff was very professional and were carefull hooking up all the saftey gear to the car.
 Wheel Chuks added.
 One wire goes to and clips on a spark plug. The other wire seems to be a controller unit used when the test begins.
 Oxygen sensors in place and ready to go.
 This picture reminds me of when my Dad used to take me to the New York State Fair and watch the tractor pulls. Hmm... Wonder how much I could pull. =)
 This is Steve the owner of the Dyno shop. He had some tips and was very informative on how my car tested.
 Going no where fast!!!
 Steve had an extra monitor set up for remote viewing. This was my first run.
 During a run.
 Second Run.
 Here are my test results. Blue shows second run. The engines raw HP turned out to be 347.95. Not bad for no engine mods installed. Not yet?
 Here were most of the cars that ran at the Dyno. All CorvetteFourm members. Also MeanGreen2000 made this event happen and thanks Mark. Had an awesome time!!!
|
|
|